
E-T2 Strength type ceramic tile adhesive
- 20 kg/bag
- Specifications:
- Implementation standards:
- Frequency
- Views:
- Downloads:
Product Features
Cohesive force is stronge; asy construction; Water resistance and weatherability.
Where to use
1. Suitable for size less than 600 mm * 300 mm ceramic tile in the indoor and outdoor
concrete or cement mortar wall body or vertical paste, high-level exterior appropriate chooses Elokt strong ceramic tile adhesive;
2. Suitable for any size of floor tile shop sticks.
Construction Technology
【Base level requirements】
Base should be firm, smooth, dry, clean, no oil, wax stains, concrete curing agent and other loose objects.
【Stirring and mixing】
1. The water poured into the container first, and then add the powder in proportion, with
an electric mixer to form a fully agglomerate, uniform paste, if let stand for 5-10 minutes and then paste mixing use 1 to 2 minutes, the effect is much better.
2. The proportions 【water: powder = (4.8 5.2) kg: 20 kg.】
【Construction technology】
In tooth type scraper paste and apply to the work surface, uniform distribution and into
strips dentate, each about 1 ㎡ daub, then rubbing on the pressure in the ceramic tile;
2. Such as ceramic tile on the back of the groove is deeper, in addition to with ceramic
tile adhesive on the surface of the work, but should also in ceramic tile with adhesive on the back.
Dosage of reference
With 3 mm * 3 mm tooth type scraper, 1.8 kg / ㎡ (in the case of base level)
With 6 mm x 6 mm tooth type scraper, about 3.0 kg / ㎡ (in the case of base level)
With 10 mm x 10 mm tooth type scraper, about 4.6 kg / ㎡ (in the case of base level)
Technical Data Sheet
Index (In accordance with the international industry standard JC/547-2005 C1 technical requirements) | |
Tensile adhesive strength | ≥ 0.5 MPa |
Afer flooding tensile adhesive strength | ≥ 0.5 MPa |
Hot tensile adhesive strength after the cold | ≥ 0.5 MPa |
After freezing and thawing cycle tensile adhesive strength | ≥ 0.5 MPa |
Open assembly time,20min tensile adhesive strength | ≥ 0.5 MPa |
Matters Attention
1. This product is suitable for use in 5 ℃ and 40 ℃ environment, avoid by all means mix has been hard of slurry water reuse;
2. Before construction must first confirm that the material end verticality and flatness, the
shop is stuck to complete after 24 hours, before entering or caulking.
Product color
White, gray
Packaging and Storage
This product is 20 kg/bag, should be stored in a cool, dry place, not unsealed product can be kept up to 12 months.