E-S82 Surface used anti-cracking water resistance putty
- Implementation standards：
Where to use
Suitable for building exterior wall cement mortar, concrete, lime mortar base on coating before blow be bored with fine leveling. With E - S81 Base used anti-cracking water resistance putty at the grass-roots level, can provide a perfect for all kinds of exterior wall coating coating base level.
1. The product of only group share, add water gently used, to ensure the construction quality.
2. Good resistance to permeability, stay dry wall;
3. Strong crack resistance, eliminate microcrack;
4. The two-way affinity, particularly strong cohesive force;
5. Aging resistance, ensure finish lasting;
6. Surface is smooth, save the coating;
7. Non-toxic, no radiation, environmental protection products.
Metope should be clean, strong and smooth, no empty drum, no pulverization, without grease stains and other loose materials. Before construction if the temperature too high or too dry, metope should be ahead of wetting metope, stay without water construction.
【Stirring and mixing】
First to add water in proportion to the container, then slowly pour into powder, with an electric mixer at the same time into uniform no grain of paste, and then let stand for 5 minutes and make a little stir again can use. Mixing ratio: [ water: powder = (8-9) kg: 25 kg.]
【Construction and maintenance】
1. Stir with scraper will good putty with the base surface, and then erased, general scraping wipe it twice;
2. The construction of every times the thickness of 0.5 ~ 1 mm (more than the thickness should be stratified batch), two times construction time interval about 4 hours (depends on the weather);
3. The last time putty after completion of construction, Suggestions within 1 ~ 2 days with more than 500 mesh fine sand paper will leave a mark or uneven of the construction of the sand. Grinding the metope after dust clean or rinse off with clear water.
4. To drench water scraping putty layer after curing, can accelerate the basic cutting speed, 3 ~ 7 days later when the PH value in meeting the requirements of the coating, can besmear to brush all kinds of exterior wall coating.
Technical Data Sheet
Drying time（Surface drying ) ,h
|Initial dry cracking resistance（6h）|
|Manual can be polished|
Water absorption /（g/10min）
Adhesive strength /Mpa
1. This product is suitable for use in 5 to 40 ℃ environment;
2. Not in the rain under the condition of construction;
3. Stir well putty should be finished in 2 to 3 hours, shall be maintained during intermittent stirring;
4. Avoid by all means will have hard putty water mixing before use.
Health and Safety
This product is alkaline, should avoid contact with the skin for a long time to avoid a large number of inhalation of dust and pay attention to eye protection, the eyes, please rinse immediately with plenty of water and immediate medical attention.
1.3 kg/m2 / mm (surface roughness affects the dosage)
Packaging and Storage
This product is 20 kg/bag, should be stored in ventilated, dry place, pay attention to moistureproof.
Submissions of product, shelf life 12 months.